Since I've exhausted all of my ideas (I also tried looking at the registry to find differences etc. One, the MM1, shows " On Apple Wireless Mouse", the other, MM2, shows " On Bluetooth HID-device". When I go to the hardware tab there's a difference between both mice's "location". When the MM2 is the only mouse connected the tab disappears. When only the MM1 is connected and I open the Mouse settings it has a "scroll-wheel" tab. Here's some more of my findings:īoth mice connected doesn't seem to cause any trouble but, for every step above, I also tried with only the MM1 or MM2 connected. Uninstalled the driver manually, which failed for some reason on several occasions, but, a couple of reboots and "persuading" later I had my mouse (or mice) finally back to where I got started.īut, still, the MM1 scrolls just fine, the MM2 doesn't want to. It turns out MagicUtilities also installs a driver but doesn't uninstall it didn't remove it in my situation. On boot the mouse worked fine I could click and move it without issue until MagicUtilities loaded (in the taskbar). Even not after rebooting, again trying all of the above with pairing, unpairing, switching off and on etc. The pointer would jump instead of move with second+ intervals, the mousebutton(s) didn't react to anything.
Shouldn't be that difficult, right? Disconnect the "1", connect the "2" and go! I have been using an Apple Magic Mouse "1" for quite some time now on my Windows 10 PC and I was very content except the damn batteries that needed replacing every once in a while.
0 kommentar(er)
